Helping Trees Survive Planting

Trees and shrubs add beauty and value to a home’s landscape. But as few as 50% of planted trees do not survive beyond one or two years. Why? Improper installation is the leading cause of failure of newly planted trees. You can grow trees successfully if you are aware of a few important planting guidelines.

Planting the biggest tree you can afford is not always the best option. Though it is true 2” to 4” caliper trees give an instantly-landscaped look to homes, these trees are more prone to transplant shock and water stress. Transplant shock occurs from the loss of root system when the tree is dug from the nursery. As much as 95% of the plant’s roots may be removed during the digging process. This means fewer roots are available to provide
water to the many branches and leaves. Symptoms range from scorch on the edges of leaves, dieback in the crown, increased vulnerability to diseases, insects, and drought, or tree death. Transplant shock, more or less, continues until the tree canopy and tree roots come into balance.container plants

Planting too deeply can kill trees. This problem may occur from three causes. First, overambitious hole diggers can dig the planting hole too deep for the root ball. Backfill placed in the bottom of the hole that is not re-compacted will allow the root ball to sink as the soil settles. Avoid this situation by measuring the height of your root ball and
leaving about 10% of the ball aboveground. Another common mistake is excessive mulching. Excessive mulch reduces the amount of oxygen reaching the roots, causing them to grow into the mulch. During a drought the mulch will dry out as will the roots,
thus causing root loss. Never apply more than 2 to 3 inches of mulch. Finally, sometimes trees may be shipped from the nursery already at a disadvantage. Container stock that has been transplanted into larger pots could have its roots buried in the process. Balled and burlapped trees may have extra soil on the top of the ball due to cultivation and digging. As a result, the roots become too deep in the ball or container. Inspect trees at the time of purchase to see if the root flair (the place where the trunk becomes the roots) is near the surface. Ones that are 2 or more inches below the surface should be avoided or at the very least remove the soil until you can see the root flair when planting. Remember to use only the existing soil on site when filling in your planting hole, no amendments should be added.

It’s okay to loosen or even cut the roots. When planting container grown trees be sure to remove the container and inspect for circling roots. You may be able to tease these roots loose from the media and spread them out in the planting hole. If a plant is severely pot-bound, use a knife or pruners to make vertical slices through the roots in several places to divide compacted roots. Leaving circling roots will eventually lead to girdling of other roots or the tree trunk itself. Girdling restricts the movement of water to the tree’s canopy and can lead to decline. Also, be sure to remove tags, wires, or ropes from the
stems or trunk of plants.

Submitted by Kelly Jackson, Agent for Horticulture, Christian Co. Cooperative Extension Service